Where To Put The Confetti Cannon?

The placement of the Confetti Cannon depends on where you want the confetti to be shot and dropped. The confetti will rise 35 feet tall and then spread out. You need to place the cannon close enough to the area to be covered with paper scraps.

Cover the stage area

You can place the Electric Confetti Cannon on any side of the stage aimed at the center. In this way, confetti will fly up from both sides of the stage. The confetti will meet in the center of the stage and fall on the stage area.

You can also place them all at the back of the stage, aiming at the front. The confetti will immediately explode and spread all over the stage area. The confetti will be scattered on the stage and float down.

Electric Confetti Cannon

Reach audience

To cover the audience, you can place them on the floor in front of the stage. Point them above the audience. Confettiwill fly in the auditorium. It will be scattered across the auditorium.

Ignite confetti

The confetti cannon is controlled by 110v electric power. There is no power switch on this unit. They must be plugged into a socket that can be controlled by an on-off switch. Most people use the on/off switch to plug the cannon into the switchboard. When you're ready to shoot with confetti, just turn on the power switch. The confetti shot out immediately. After the confetti is in the air for 5-10 seconds, be sure to turn off the power.

You can also plug the confetti cannon into a 110v socket controlled by DMX.